Coldelite UF-253G 매뉴얼 - 페이지 7
{카테고리_이름} Coldelite UF-253G에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coldelite UF-253G 17 페이지. Gravity soft serve freezers
페이지 인쇄21) Disassemble the beater/auger by first removing the rubber
beater shaft (lip) seal, simply slide it off the shaft.
25) Wash all the parts in luke warm water (80"
-
85'F) using a
mild detergent and the cleaning brushes provided in the
START-UP KIT.
DO NOT USE HOT WATER O N ANY OF THE PLASTIC
PARTS AS DAMAGE TO THE PARTS CAN RESULT.
41
Alr
Dry
3'
San'tlze
\
t
22) Continue disassembly by removing the beater IDLER. Pull
forward until the grooved portion of the shaft lines up with
the opening at the front of the beater/auger. Lift the idler
up and out.
n
Figure 10
26) Rinse the parts in luke warm water (80
-
85
F)
27) Place the parts in luke warm, sanitized water for 2 to 5
minutes. Use the sanitizer provided In the START-UP KIT
following the manufacturers directions.
23) Finally, remove the beaterlauger END PUSHER by pulling
straight and away from the beater.
24) The machine is now completely disassembled. The parts
should now be washed, rinsed and sanitized.
28) Place the parts on a clean, sanitized counter area and
allow to air dry or assemble wet. DO NOT TOWEL DRY OR
RINSE SANITIZED PARTS.