DADO AQUALINE BASIN MIXER Series 설치 매뉴얼 - 페이지 5

{카테고리_이름} DADO AQUALINE BASIN MIXER Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DADO AQUALINE BASIN MIXER Series 7 페이지.

INSTALLATION PREPARATION

If major work is done on the home, the water network must be flushed of all impurities to avoid damaging

your mixer.

1. Flush out the inlet pipes well before starting with the installation, this will remove any solid

objects that may block the tap once in use. Install an in-line strainer to prohibit future damage

to the cartridge or blocking of the aerator.

2. Ensure that you have balanced pressure not higher than 3-bar or 300kPa. This can be achieved

by placing a pressure-reducing valve before both the hot and cold take off.

3. Use the correct tools for installation and always place a protective cloth over visible chrome

parts that require spanner tightening.

4. Before dismantling your old unit identify the hot and cold-water lines, then shut off the water

supply. We recommend the use of angle regulating valves on all basin mixers. This helps to

isolate the tap without turning off your entire water supply.

1. Screw the flexi hoses and the threaded posts into the mixer body and tighten by hand.

2. Pick up the mixer and water-tight seal, place the seal on the vanity and insert the hoses into

the mixer hole on the vanity.

3. Place the mixer so that the water-tight seal is in contact with the vanity. Hold the mixer in this

position. Hint: use the hoses to hold the mixer firmly until it is attached.

www.dado.co.za

ADHERE TO ALL LOCAL BUILDING AND PLUMBING CODES. THE DIAGRAMS IN THIS GUIDE ARE NOT CONSTRUCTION PLANS; THEY ARE VISUAL AIDS.