Daedalon EC-33 사용 설명서 - 페이지 5

{카테고리_이름} Daedalon EC-33에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daedalon EC-33 6 페이지.

페이지 인쇄

EC-33 Geiger Computer Interface USB

Controllers", and check to be sure that this is

activated and functioning correctly.

If there is no entry for the USB controller in the

Device Manager, be sure that the USB controller is

enabled at the BIOS level for the computer. Be sure

that any device drivers relevant to the USB controller

have been installed. A customer support website for

a computer manufacturer will generally provide both

advice and updated device drivers.

Try another USB cable. Avoid using cables longer

than 2 meters.

If it is possible to operate other USB peripherals on

the computer but the Daedalon Interface will not

work, try installing the Interface on a different

computer. Contact Daedalon customer support and

provide as much information as possible.

Specifications

Counting

Geiger Tube:

High Voltage:

Warning

General

Power

Connections

Indicators

Controls

Daedalon EN-01 or EN-04 tubes are

recommended. Most end-window Geiger

tubes can be used.

450 or 900 Vdc presets, 0-1200V adjustable

via front panel control.

Excessive voltage indicated by continuous

glow of the "COUNTING" light with no

source present. This rapidly wears out the

GM tube and must be avoided.

may be read from the interface using

provided software.

The interface draws 5 Vdc directly from the

computer's USB port. Current draw is

250mA max.

Two Meter USB 'A' to 'B' cable. Dual color-

coded 4mm banana jacks for GM tube.

Two panel LED lights for status and

counting indications. Internal transducer for

audio output of tube counts.

AUDIO and GEIGER TUBE VOLTAGE slide

switches on front panel. Front panel knob

for adjusting voltage (0-1200 Vdc).

Voltage