DAEHAN STAR F04 White 사용자 설명서 - 페이지 4

{카테고리_이름} DAEHAN STAR F04 White에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAEHAN STAR F04 White 4 페이지. Super bright s-led module

User Guide

TROUBLE SHOOTING

STAR RGB C04

Entire sign or leg does not light

after complete installation.

Still does not light.

Beginning of a leg lights, but the

entire leg does not light or lights

intermittently.

One module does not light, but

all others in the leg light.

All modules light, but some of

them are dimmed.

Dark spots or dimmed spots

occur.

Still has spots.

DAEHANTRANS CO.,LTD

#7-11 Songdo-Dong, Yeonsu-Gu, Incheon, Korea

Tel. +82 32 858 0491 Fax. +82 32 832 8421 [email protected] / www.daehantrans.com

Check connection from power supply lead to ﬁrst module. Make sure polarity of connections

made at the power supply lead and any jumper wire is correct. Power supply outputs should

be connected red-to-red and white-to-white.

Check output voltage of power supply using a voltmeter. The output voltage should be

12.0VDC ± 0.5VDC. If there is no output voltage, have a licensed electrician check input

voltage. Make sure power supply is connected correctly and getting primary power. If power

supply is connected properly and getting primary power and there is still no output voltage,

try a diﬀerent power supply.

If power supply is getting primary power and the modules do not light, there may be a short

in the secondary wiring. Check all connections and cap all loose wires.

The primary cause of a portion of a S-LED leg not lighting or lighting intermittently is a bad

connection or reverse polarity connection between the modules that light and the modules

that don't light. Check this connection.

S-LED is designed so if one module fails, it will not cause the entire sign or leg to go out. If one

module does not light, but all others in the leg do, replace this module with a new one.

Check each run has no more than maximum number of modules. Also ensure that type of the

extension wire from SMPS to the ﬁrst module is correct. If wires are not thick enough to

transmit current from SMPS, this will cause voltage drop and will dim the modules at the end.

Channel depth is too low, or center distance between modules is too far. Refer to 'LAYOUT

DENSITY GUIDELINES' for more information.

Covering acrylic is not intended for LED illumination. Use light diﬀusing acrylic sheets which

are specially made for LED light source.