Air Hogs Vectron Wave 사용 설명서 - 페이지 4

{카테고리_이름} Air Hogs Vectron Wave에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Air Hogs Vectron Wave 4 페이지.

페이지 인쇄

PROBLEM

Charger LED is

flashing Green.

Vectron

Wave will not

start or has lost power.

Vectron

Wave is flying

too low.

NOTE: If normal function of the product is disturbed or

interrupted, strong electro-magnetic interference may be

causing the issue. To reset product, turn it completely off,

then turn it back on. If normal operation does not

• Requires 6 x 1.5-V AA alkaline batteries (not included).

• Batteries are small objects.

• Replacement of batteries must be done by adults.

• Follow the polarity (+/-) diagram in the battery compartment.

• Promptly remove dead batteries from the toy.

• Dispose of used batteries properly.

• Remove batteries for prolonged storage

• DO NOT incinerate used batteries.

Your Vectron

Wave is equipped with a

Lithium Polymer battery.

SPECIAL LiPO BATTERY INSTRUCTIONS:

• Never charge battery unattended.

• Charge battery in isolated area. Keep away from flammable

materials.

• Do not expose to direct sunlight.

• There is a risk of the batteries exploding, overheating, or

igniting. Do not disassemble, modify heat, or short circuit

the batteries. Do not place them in fires or leave them in

hot places.

PRODUCT BATTERY REMOVAL INSTRUCTIONS:

Internal battery is factory installed, product disassembly and

battery removal must be performed by an adult. Do not use any

tools for disassembly. Pulling, tearing, and deforming of the

product during disassembly, while necessary, should be as limited

as possible. Do not compress the product at any time. Ensure

product is turned off. Find a point where the two body halves

meet; the nose of the aircraft or where the wing meets the body.

Start to peel the halves apart, separating them where they are

Imported by:

SPIN MASTER INTERNATIONAL, S.A.R.L., 16 AVENUE PASTEUR, L-2310, LUXEMBOURG

www.spinmaster.com

Air Hogs

is a registered trademark of Spin Master Ltd. and Vectron

future reference. • Please remove all packaging materials before giving to children. • An adult

should periodically check this toy to ensure no damage or hazards are found, if so, remove

from use. • Children should be supervised during play. • Keep addresses and phone numbers

for future reference. • The item inside this package may vary from the photographs and/or

illustrations. This product conforms to safety requirements of EN71. MADE IN CHINA.

20043842, 20043843 EML English REV 0

T44363_0109_20043842_EML_IS_R1

20051555, 20051556 EML English REV 0

T44363_0118_20051555_EML_IS_R1

TROUBLESHOOTING cont'd...

CAUSE

Batteries in charger are low.

1. You have not set the motor switch

to "ON".

2. Charger battery power is low.

3. Batteries (+) or (-) are not correctly

placed inside the battery compartment.

4. Vectron

Wave battery is low.

1. The batteries in the charger are drained.

2. Vectron

Wave s battery is low.

3. Hair or debris may be caught in the rotor.

IMPORTANT BATTERY INFORMATION

is a registered trademark

Install new batteries in charger.

1. Slide motor switch to "ON".

2. Replace the charger batteries.

3. Be sure to align the (+) and (-) polarities

with the corresponding markings inside

the battery compartment.

4. Recharge Vectron

1. Install new batteries in charger.

2. Recharge Vectron

3. Remove hair or debris.

resume, move the product to another location and try

again. To ensure normal performance, change the

batteries, as low batteries may not allow full function.

• DO NOT dispose of batteries in fire, as batteries may explode

or leak.

• DO NOT mix old and new batteries or types of batteries

(i.e. alkaline/standard).

• DO NOT use rechargeable batteries.

• DO NOT recharge non-rechargeable batteries.

• DO NOT short-circuit the supply terminals.

• Do not drop or subject to strong impacts.

• Do not allow the batteries to get wet.

• Only charge the batteries with the specified Spin Master™

battery charger.

• Only use the batteries in the device specified by

Spin Master™.

• Carefully read the instruction guide, and use the batteries

correctly.

• In the unlikely event of leakage or explosion use sand or a

chemical fire extinguisher for the battery.

• Batteries must be recycled or disposed of properly.

glued together; remove any tape as necessary. Separate

product body halves to expose internal electronics. To separate

battery from product use scissors to cut a single battery wire,

immediately wrap the cut wire end with tape to isolate it, repeat

until all battery wires are cut and isolated. Dispose of battery in

accordance with your local battery recycling or disposal laws.

NOTE: Opening of product and/or removal of battery will render

product inoperative and voids manufacturer warranties, dispose

of remaining product components in accordance with local laws.

Contains 1 LiPo battery pack. • Battery pack must be recycled or disposed of

properly. • If at any time in the future you should need to dispose of this product

please note that Waste Electrical Products should NOT be disposed of with

household waste. Please recycle where facilities exist. Check with your Local

Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive).

SOLUTION

Wave.

Warning:

CHOKING HAZARD –

Small Parts.