DAELECTRONICS iCtrl-R-mini 운영 매뉴얼 - 페이지 4

{카테고리_이름} DAELECTRONICS iCtrl-R-mini에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAELECTRONICS iCtrl-R-mini 8 페이지. Pocket midi controller
DAELECTRONICS iCtrl-R-mini에 대해서도 마찬가지입니다: 운영 매뉴얼 (8 페이지), 운영 매뉴얼 (8 페이지), 운영 매뉴얼 (8 페이지)

페이지 인쇄

During mode 2 you can switch to mode 1 holding for approx a second the switch 1 (exit from mode 2 without saving) or the switch 2 (exit from

mode 2 saving modifications).

Led blinking will notify the switch from mode 2 to mode 1.

Assign Control Changes to effects inside software

In Amplitube on iPad press with a finger on a virtual switch that you want to control with the switches on the controller until the appearance of the

word "learn". In Jam up you should open the midi settings, select the parameter to be controlled and manually change the CC in CC 1,2,3,4,5,6,7 or

8 (check that no other parameter can be controlled with the same CC) or you can use the function "learn". When you activate the "learn" function

please click or long click on the foot switches on the controller and the synchronization is automatic.

See APPENDIX for MODE 3 and 4

Leds Syncronizing

Mode 2 - Led Memory Bank - Sync and Save

in mode 2.

This gives you 8 different led configurations which correspond to each of the 8 patches you select in mode 1.

These configurations are saved and linked to each mode 1 switch then recalled each time you enter mode 2.

Once set up and saved, the

in mode 1.

To set up and save all 8 banks you must first be in mode 1:

1. After selecting your effect patch by selecting switch , enter mode 2 by stepping on button 2 for 1 second;

2. Let's make sure led on the

by turning all the

software/daw/rack;

3. Turn on the effects you want saved in your patch, do this with the buttons on the

software/daw/rack;

4. Save the setting on the

second;

5. After saving the setting on the

6. After saving the

iCtrl-R mini

mode 1;

7. Select switch 2 and repeat the process for all 8 switches and you

iCtrl-R mini

's led lights will be in sync with all the effect on/off positions you have in each of the 8 patches assigned

iCtrl-R mini

are in sync with your effect on/off states in that patch on your software/daw/rack . Do this

iCtrl-R mini

led lights off, by stepping on the buttons. Now also off all your effects from within your

iCtrl-R mini

by holding down button 2 for 1 second or exit without saving by holding down button 1 for 1

iCtrl-R mini

save your patch in your software/daw/rack in the same state;

iCtrl-R mini

will return to mode 1 on the previous selected patch. Led blinking will notify the switch from mode 2 to

to your patch FX. Each of the 8 switches in mode 1 has its own led light memory bank

iCtrl-R mini

will be totally in sync with your gear.

iCtrl-R mini

, so they light up, don't do it inside you