Asus 815 사용자 설명서 - 페이지 13

{카테고리_이름} Asus 815에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus 815 27 페이지. Intel 815 microatx motherboard

3. HARDWARE SETUP

3.4 System Memory (DIMM)

NOTE: No hardware or BIOS setup is required after adding or removing memory.

This motherboard uses only Dual Inline Memory Modules (DIMMs). Sockets are

available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random Ac-

cess Memory (SDRAM). One side (with memory chips) of the DIMM takes up one

row on the motherboard.

Memory speed setup is recommended through SDRAM Configuration in 4.4.1

Chip Configuration.

Install memory in any combination as follows:

DIMM Location

Socket 1 (Rows 0&1)

Socket 2 (Rows 2&3)

NOTE: If the total installed memory exceeds 512MB, the system will hang during

startup.

•

For the system CPU bus to operate at 133MHz, use only PC133-compliant

DIMMs.

•

Motherboards support SPD (Serial Presence Detect) DIMMs. This is the memory

of choice for best performance vs. stability.

•

Single-sided DIMMs come in 16, 32, 64,128, 256MB; double-sided come in 32,

64, 128, 256, 512MB.

168-pin DIMM

SDRAM 8, 16, 32, 64, 128, 256, 512MB x1

Total System Memory (Max 512MB)

CUSL-L User's Manual

Total Memory