Daema DWF-7688KG 사용자 설명서 - 페이지 7

{카테고리_이름} Daema DWF-7688KG에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daema DWF-7688KG 10 페이지.

페이지 인쇄

Operation steps

1. Press power switch, put through power, the machine is in state of beginning:

2. Press "program"button to select proper program.

3. Select appropriate water level according to your laundries quantity.

4. At the beginning of start, if need to select air-dry, press"Program" button to select

"Air dry", When the air dry function is over, the washing machine will be in waiting

state.

5. Close the top lid, press Start/Pause, the washing machine is working.

6. When the washing is finished, buzzer alarm, power supply cut off automatically.

How to use drainpipe

Install drainpipe

Set drainpipe clip into the drainpipe to 2-3cm (from the drainpipe end that without pothook

to set), then install the drainpipe into the right drianpipe connector and fix the drainpipe

and drianpipe connector with the clip,after that put up the drainpipe clip on the cabinet.

How to change the direction of the drainpipe

1.Take off the drainpipe and drainpipe clip from

drainpipe connector, put some soft mat on the floor,

make washing machine front side adown and gently

put down the washing machine front side on the mat,

demount the screws on the back cover with screwdriver

and take out the back cover. Demount one screw that

fixed the drainpipe connector(on right of the washing

machine), loosen the drainpipe connector.

Drainpipe clip

Drainpipe connector

Drainpipe

(Section sketch map for washing machine right side)

3. With proper force to take down drainpipe gate stopper

on left side of the washing machine. The drainpipe gate

stopper is fixed on washing machine base with two

clips, please see the fixing type from the place of

opening back cover.

Drainpipe gate stopper

（Section sketch map for washing machine left side）

Water drainage

The drainpipe should drain smoothly

1.The height of the drainpipe should be less

than 10cm, otherwise the drainage will not be

smooth and need a long time to drain, the machine

may stop during working.

2.Do not step on or press the drainpipe.

3.Cut the drainpipe if it is too long. Cut the front end of the

drainpipe slantingly to make drainage smoothly.

2. Extrude the drainpipe with proper force

and take out drainpipe hoop(on right of the

washing machine),make the the inner

drianpipe loosen.

Drainpipe hoop

（Section sketch may inside washing machine）

4. Pull the inner drainpipe to another side ,

please do not make the inner drainpipe

distortion; as per foregoing description,

fix inner drainpipe with drainpipe hoop,

with one screw fix drainpipe connector,

install the drainpipe gate stopper to

another side, make washing machine

standing gently,fix back cover with screw

and install the drainpipe and drainpipe

clip into the drainpipe connector.

4. Purchase a proper hose if you need additional

drainpipe. Its diameter should not less than

30mm and length should not exceed 1.5m.

5. If the additional drainpipe is too long,

cut some at A or B point.

A B