Asus A7V-VE 빠른 시작 매뉴얼 - 페이지 20
{카테고리_이름} Asus A7V-VE에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus A7V-VE 21 페이지. Athlon / duron microatx motherboard
페이지 인쇄2. HARDWARE SETUP
The following diagram is for items 16-22 the Panel connector:
A7V-VE
A7V-VE System Panel Connectors
16) System Message LED Lead (2-pin MLED)
This indicates whether a message has been received from a fax/modem. The
LED will remain lit when there is no signal and blink when there is data re-
ceived. This function requires an ACPI OS and driver support.
17) System Management Interrupt Lead (2-pin SMI)
This allows the user to manually place the system into a suspend mode or "Green"
mode, where system activity is decreased to save electricity and expand the life
of certain components when the system is not in use. This 2-pin connector con-
nects to the case-mounted suspend switch.
18) System Warning Speaker Connector (4-pin SPK)
This 4-pin connector connects to the case-mounted speaker.
19) Reset Switch Lead (2-pin RESET)
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch. This is a preferred
method of rebooting to prolong the life of the system's power supply.
20) System Power LED Lead (3-pin PLED)
This 3-pin connector connects the system power LED, which lights when the
system is powered on and blinks when it is in sleep mode.
21) IDE Activity LED (2-pin IDELED)
This connector supplies power to the cabinet's IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE connector
will cause the LED to light up.
22) ATX Power Switch Lead (2-pin PWR)
The system power is controlled by a momentary switch connected to this lead.
Pressing the button once will switch the system between ON and SOFT OFF.
Pushing the switch while in the ON mode for more than 4 seconds will turn the
system off. The system power LED shows the status of the system's power.
20
Speaker
Speaker
Ground
Connector
Ground
SMI Lead
ExtSMI#
Message LED
MSGLED-
MSGLED+
Requires an ATX power supply.
*
A7V-VE User's Manual
Ground
Reset SW
Reset
PWRLEDB-
Power LED
+5V
PWRLED-
PWRLED+
IDELED+
IDELED
IDELED-
Ground
ATX Power
PWRBTN
Switch*