Asus A7V8X-LA Kamet 2 사용자 설명서 - 페이지 12
{카테고리_이름} Asus A7V8X-LA Kamet 2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus A7V8X-LA Kamet 2 18 페이지. Kamet 2
페이지 인쇄
- 1. Table of Contents
- 1. 1 Motherboard Layout
- 2. A7V8X-LA Specification Summary
- 2. 2 Central Processing Unit (CPU)
- 2. Installing the CPU
- 3. 3 System Memory
- 3. Installing a DIMM
- 4. 4 Expansion Slots
- 4. Standard Interrupt Assignments
- 4. IRQ Assignments for this Motherboard
- 4. PCI Slots
- 4. AGP Slot
- 5. 5 Jumpers
- 6. 6 Connectors
6. Connectors
This section describes and illustrates the internal connectors on the motherboard.
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug.)
A7V8X-LA (KAMET2)
A7V8X-LA (KAMET2) Floppy Disk Drive Connector
2. ATX power connectors (20-pin ATXPWR; 4-pin ATX12V)
These connectors connect to an ATX 12V power supply. The plugs from the
power supply are designed to fit these connectors in only one orientation. Find
the proper orientation and push down firmly until the connectors completely fit.
Make sure that your ATX 12V power supply can provide 8A on the +12V lead
and at least 1A on the +5-volt standby lead (+5VSB). The minimum
recommended wattage is 230W, or 300W for a fully configured system. The
system may become unstable and may experience difficulty powering up if the
power supply is inadequate.
A7V8X-LA (KAMET2)
A7V8X-LA (KAMET2) ATX Power Connectors
8
+12.0VDC
+5VSB
PWR_OK
COM
+5.0VDC
COM
+5.0VDC
COM
+3.3VDC
+3.3VDC
ASUS A7V8X-LA Motherboard
FLOPPY
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
ATXPWR
+12V DC
+5.0VDC
GND
+5.0VDC
-5.0VDC
COM
COM
COM
PS_ON#
COM
-12.0VDC
+3.3VDC
ATX12V
+12V DC
GND