Dorex DX1 PV/FV 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Dorex DX1 PV/FV에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dorex DX1 PV/FV 12 페이지.

페이지 인쇄

05. INSTALL BOTTOM STRIKE

Pullman Latch

DXAS224

DXAS227

Strike

1. Mark floor for fasteners, prepare floor according to the

type of strike and fastener furnished. Provide clearance in

floor for bolt.

2. For threshold application: Provide hole in threshold

according to type of strike and fasteners furnished.

07. INSTALL TRIM (IF USING) AND SECURE DEVICE CENTER CASE TO DOOR.

1-1/2" minimum clearance (with end cap

removed) if device is too long for door,

see "CUT DEVICE" on page 11.

Center

Case

Screws

1. DEVICE WITH TRIM - See "Trim Instructions".

2. CYLINDER ONLY - Install cylinder with cylinder back plate as shown. Make sure the tailpiece is

extending 1/2" from the inside face of door. Insert tailpiece into cam in the center case and mount

it to the door with four(4) center case screws.

3. EXIT ONLY - Mount center case to the door with four(4) center case screws.

Round Bottom Latch

DXAS225

DXAS226

Strike

Trim

(Optional)

Back Plate

06. DETERMINE USE OF NIGHT LATCH (NL) DRIVE SCREW

NL Drive Screw

NL driver screw is factory assembled in cam on back of device

center case, when the NL drive screw is left in back of center

case, the outside cylinder will function only as a Night Latch.

NOTE: 1. DO NOT remove NL drive screw for Pull Plate or

Escutcheon with night latch cylinder.

2. REMOVE NL drive screw from back of center case

when installing trim that has a functional lever,

knob, or thumbpiece AND an outside cylinder to

lock and unlock the trim.

Cylinder Screws

Cylinder

Cam

Removal Tool

(5/64" Hex Wrench)

1/2"

Cut tailpiece if needed