Asus B150-A 사용자 설명서 - 페이지 11

{카테고리_이름} Asus B150-A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus B150-A 27 페이지. Pin definition
Asus B150-A에 대해서도 마찬가지입니다: 기술 매뉴얼 (18 페이지)

ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)

Correctly orient the ATX power supply plugs into these connectors and push down

firmly until the connectors completely fit.

•

CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN )

Connect the fan cables to the fan connectors on the motherboard, ensuring that

the black wire of each cable matches the ground pin of the connector.

Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside

the system may damage the motherboard components. These are not jumpers! Do not

place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan

of maximum 1A (12 W) fan power.

Intel

Install Intel

designed for 6th Generation Intel

processors.

For more details, refer to Central Processing Unit (CPU).

DDR4 DIMM slots

Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these

DIMM sockets.

For more details, refer to System memory.

Intel

These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA

6.0 Gb/s signal cables.

When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to

[AHCI].

1-2

For a fully configured system, we recommend that you use a power supply unit

(PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides

a minimum power of 350 W.

If you are uncertain about the minimum power supply requirement for your system,

refer to the Recommended Power Supply Wattage Calculator at http://support.

asus.com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for

details.

LGA1151 CPU socket

LGA1151 CPU into this surface mount LGA1151 socket, which is

B150 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)

Core™ i7 / i5 / i3, Pentium

Chapter 1: Product introduction

, and Celeron