Daessy DSAM4 조립 지침 매뉴얼 - 페이지 2

{카테고리_이름} Daessy DSAM4에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daessy DSAM4 6 페이지. Swing aside mount

페이지 인쇄

Identify the Parts

Use the parts list and diagram below to identify each part and ensure all parts are included.

Part Code

Part Name

S22x3

Vertical S-bend Tube (22" long with 3"

offset)

Horizontal Tube

Swing Aside Rotate Head, Tube &

Assembly

Cable

ROP-RFCR

Removable Outer Piece & Receiver

UFCxxxxIP or

Frame Clamp (*parts will vary based on

MH3/IPA

wheelchair, look for anything with an IP

or IPA engraved on it)

TUSB

Total Quick Release Base

Tools

Assembly Tools

Assembly Instructions

The Frame Clamp Assembly

This step requires 2 components:

• Frame Clamp (UFCxxxxIP)

• RFCR

The Frame Clamp varies depending on the type of wheelchair, it may not be exactly as shown, "Frame

Clamp" most commonly refers to UFCxxxxIP, but there are others all of which will include IP or IPA in

their part code. These instructions are

specific to mounts with a UFCxxxxIP;

other types of frame clamps will include

separate assembly instructions. Identify

the Frame Clamp and the RFCR.

• Remove the cap from the Frame

Clamp.

• Remove the Swivel Clamp from

the RFCR.

Align the grooves on the RFCR with the grooves on the frame clamp (photo below left). Put the non-

threaded half of the swivel clamp into the RFCR (with the bolts pushed through). Put the threaded half

into the Frame Clamp body and begin tightening the bolts, alternating between the two. Do not fully

tighten the bolts. The RFCR and the UFCxxxxIP should be able to swivel freely. See photos below.

Printed in Canada

Manufactured by Daedalus Technologies in Canada

Swing Aside Mount Assembly

www.daessy.com

DSAM4

Page 2 of 6