Asus CUV4X-CME 사용자 설명서 - 페이지 7

{카테고리_이름} Asus CUV4X-CME에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus CUV4X-CME 17 페이지. Pc133 agp-4x

HARDWARE SETUP

Internal Connectors

WARNING!

Some pins are used for connectors or power sources. These are

clearly distinguished from jumpers in the Motherboard Layout. Placing jumper

caps over these connector pins will cause damage to your motherboard.

IMPORTANT:

Always connect ribbon cables with the red stripe to Pin 1 on the

connectors. Pin 1 is usually on the side closest to the power connector on hard

drives and CD-ROM drives, but may be on the opposite side on floppy disk

drives.

1) Primary (Blue) / Secondary IDE Connectors (40-1 pin IDE1/IDE2)

These connectors support the provided UltraDMA/66 IDE hard disk ribbon cable.

Connect the cable's blue connector to the primary (recommended) or secondary

IDE connector, then connect the gray connector to the UltraDMA/66 slave device

(hard disk drive) and the black connector to the UltraDMA/66 master device. It

is recommended that non-UltraDMA/66 devices be connected to the secondary

IDE connector. If you install two hard disks, you must configure the second

drive to Slave mode by setting its jumper accordingly. Refer to the hard disk

documentation for the jumper settings.

CUV4X-CME

CUV4X-CME IDE Connectors

ASUS CUV4X-CME User's Manual

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PIN 1