Canon Vixia HF S21 워크샵 매뉴얼 - 페이지 8

{카테고리_이름} Canon Vixia HF S21에 대한 워크샵 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon Vixia HF S21 11 페이지. Vixia imagemixer 3 simple video editing
Canon Vixia HF S21에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지), 브로셔 (27 페이지), 매뉴얼 (26 페이지)

페이지 인쇄
Canon Vixia HF S21 워크샵 매뉴얼
8
1)
2)
3)
4)
5)
6)
7)
8)
Note:
The new BeachTek (blue one) has a ground switch [G1/G2]. Toggle
this switch if you're hearing a hum or buzz. Also on the BeachTek,
toggle between stereo and mono for the mic(s) you're using [M/S].
BeachTek DXA-2T
Mini-plug out
(on front)
XLR inputs
The XLR inputs also accept line level sources like mixers, or wireless
microphone receivers. If you're using the inputs this way, switch to LIN (line)
using the LIN/MIC switch above each channel's volume pot. The Aux Input mini-
plug accepts mono, unbalanced line sources (best with a wireless mic pack) and is
controlled by the Right volume pot. If using the Aux input, disconnect the Right
XLR cable. Follow the steps above to adjust levels for this device.
Some scenes call for major volume swings in performance and getting the best sound may
involve "riding" the custom dial in order to capture everything without distorting. Just go to the
Custom Dial setting menu to assign Mic Input level control to the dial (pg.6).
Audio Levels Cont'd.
Connect your mic to an XLR input on the BeachTek.
Connect the mini-plug coming out of the BeachTek to the
camera's mic input (item 20 on page 2).
Set the BeachTek volume pot to maximum.
Before putting on headphones, you must set the Headphone jack
for headphones. Touch [FUNC] > [MENU] >
[AV/Headphones] > [Headphones] > [X]. Set your volume.
Plug in a set of circumaural, closed-back headphones; these are
the type that totally cover your ear and help isolate you from
background noise. Check your volume.
Test the mic as if you (or subject) are performing what you'll be
recording. Don't whisper "hello...testing 1,2,3," or snap your
fingers to test the mic. Use the volume that will be performed in
order to get good audio.
Adjust the volume pot on the BeachTek so the average audio
reads about –12 dB on the camera's meter. If it's too loud, turn
down the BeachTek. If it's still too loud, start adjusting the level
in the camera [<] [>] in the Mic Level Menu.
Do a test recording now and LISTEN BACK to ensure good level.
Mounting Screw
Mic/Line Switches
Mono/Stereo
Ground Switch
Volume pots
>