bolid MP 24/12V 사용자 설명서 - 페이지 6

{카테고리_이름} bolid MP 24/12V에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. bolid MP 24/12V 9 페이지. Dc-dc power converter module

3.3

Maintenance Procedures

Annual maintenance works are carried out by service company employee and include:

1) Visual checking of the MP conditions;

2) Checking output voltage when the load is connected as per 1.2.2 – 1.2.3 of this manual and

performance of the external indicator.

3) Verifying the MP is secured reliably and external installation wires and contact joints are in

proper conditions.

3.4

Full inspecting of MP operability can be conducted only by the manufacturer or in special

laboratories.

1) Turn the MP on as discussed in 2.3.1.

2) Measure the output voltage of the MP. The output voltage value shall be within the range

indicated in 1.2.2.

3) Ensure the HL1 indicator is healthy (see Appendix B for the layout).

The MP is considered to be operational if requirements 3.4-2), 3.4-3) have been met.

3.5

Technical examination is not applicable for this equipment.

3.6

Preservation is not applicable for this equipment.

ATTENTION!

The manufacturer accepts no claims unless a malfunction report is applied

4.1. An equipment fault resulted from consumer's not observing rules of mounting and operation

is not a reason for claims and warranty repair.

4.2. Repair of faulty equipment is to be conducted by the manufacturer or in authorized repair cen-

ters. The product shall be sent for repair in compliance with Company Standard QMS 8.5.3-2015, which

can be found online at our website https://bolid.ru/support/remont/.

Attention!

The equipment shall be submitted for repair being assembled and clean and along

with all the parts listed in the documentation.

Claims are accepted only if a reclamation report describing the failure is applied to

the submitted equipment.

4.3. An equipment fault resulted from consumer's not observing rules of mounting and operation

is not a reason for claims and warranty repair.

4.4. Claims shall be submitted to the following address:

NVP BOLID, #4 Pionerskaya Str., Korolyov, Moscow Region, 141070, Russia

Phone/fax: +7 (495) 775-71-55 (PBX) E-mail: [email protected].

4.5. In case of any issue related to use of the product, please contact the technical support:

+7 (495) 775-71-55 or e-mail [email protected].

Storage in a transport container is permitted in unheated warehouses at ambient temperatures

minus 30 through +50 °С and relative humidity up to 95 % at +35 °С.