bolid S2000-SP2 사용자 설명서 - 페이지 11

{카테고리_이름} bolid S2000-SP2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. bolid S2000-SP2 18 페이지. Addressable two output alarm actuating unit

2.2.4 Wiring the Unit

Figure 2.2.5 shows the general schematic for wiring the unit.

Notes:

1. The kinds of actuating devices being connected to the outputs are defined by user and can differ from the

ones specified above.

2. Load connection modules (MPN) shall be installed inside the actuating appliances (except for starting

circuits of fixed fire extinguishing systems).

3. In case of connecting starting circuits of fire-fighting systems or equipment in explosion protected housing,

load connection modules can be installed in close vicinity from them.

4. If an output is not in use, one can replace load connection module with a 510 Ohm – 1/2W resistor.

Connecting to fixed fire-fighting systems should be conducted in accordance with the schematic

in Figure 2.2.6. The length of wires used to connect a fire-fighting systems and the resistance of the

additional resistance shall be such that the required squib activation current will be provided.

Figure 2.2.6. Preferable Diagram for Connecting a Discharge Circuit

Figure 2.2.5. General Schematic for Connecting the Unit