Canon LV 5210 - SVGA LCD Projector 사양 - 페이지 6

{카테고리_이름} Canon LV 5210 - SVGA LCD Projector에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV 5210 - SVGA LCD Projector 22 페이지. Expand serial command functional specification
Canon LV 5210 - SVGA LCD Projector에 대해서도 마찬가지입니다: 사양 (47 페이지)

페이지 인쇄
Canon LV 5210 - SVGA LCD Projector 사양
Basic Serial Functional Specification for LV-5210/7215/7210
3

Notes for Communication

3.1 The projector command is defined one command/one line that starts "C" and ends carriage
return (0x0D).
3.2 There are two types of command, functional execution commands and state read commands.
Example of Functional Execution Command: "C05" [CR]
Example of State Read Command: "CR0" [CR]
When it takes more than one second to receive on command, it clears information of buffer.
(until the projector receives the carriage return since the projector has received the first
data.)
3.3 When control command pipelining, after the response, wait interval of time, 100ms, as
below.
PC → Projector
Projector → PC
3.3.1
When a computer sends next command before receiving a return command, the
projector may not operate properly.
3.3.2
When there is no response after 5 seconds, issue next command.
3.4 It takes about 5 seconds for internal initialization after plugging in AC. During this time,
it cannot process command. Do not issue any commands.
3.5
Response for Status Read Command after accepting has different characters.
Status Read Command.
3.6 Characters for commands must be Capital (A - Z).
Command
"C""0""7"C
R
( a few ms- 5s)
More than 100ｍｓ
Next command
CR
ACK
Response
Page
See 7.
6