Canon LV 5210 - SVGA LCD Projector 사양 - 페이지 19
{카테고리_이름} Canon LV 5210 - SVGA LCD Projector에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV 5210 - SVGA LCD Projector 47 페이지. Expand serial command functional specification
Canon LV 5210 - SVGA LCD Projector에 대해서도 마찬가지입니다: 사양 (22 페이지)
페이지 인쇄
EXPAND SERIAL COMMAD FUNCTIONAL SPECIFICATION for LV-5210/7215/7210
8.5.2
CF_TDOTS COMMAND
COMMAND
"CF_TDOTS_%1" [CR]
"nnnn-9999"-- Directly set Total Dots value
%1
"UP"---------------- Total Dots setting value ＋1
"DN"---------------- Total Dots setting value-1
Set Total Dots of PC signal.（Only valid when it is in the usual Power ON
status.）
Details
The value set by this Command will not be saved to the projector.
Therefore, when ALL OFF the projector, the value will return to the original
setting. (Standby MODE stays)
Acceptable
Response
Unacceptable
8.5.3
CF_CLAMP COMMAND
COMMAND
"CF_CLAMP_%1" [CR]
"0000-0127"---- Directly set Clamp setting value
%1
"UP"------------------ Clamp setting value ＋1
"DN"------------------ Clamp Setting value -1
Set Clamp of PC signal. （Only valid when it is in the usual Power ON status.)
The value set by this Command will not be saved to the projector..
Details
（stay in STANDBYMODE.）
Acceptable
Response
Unacceptable
8.5.4
CF_H-POS COMMAND
COMMAND
"CF_H-POS_%1" [CR]
"0000-nnnn"-- Directly set Horizontal Position
%1
"UP"---------------- Horizontal Position value ＋1
"DN"---------------- Horizontal Position value-1
Set horizontal position of PC signal. （Only valid when it is in the usual Power
ON status.）
Details
This value set by this Command will not be save do the projector.
Therefore, when ALL OFF the projector, the value will return to the original
setting. (stays in STANDBYMODE)
Acceptable
Response
Unacceptable
This is current Display Dots value＋Horizontal position value
"000" [CR]
"101" [CR] ----Input-VIDEO
Therefore, when ALL OFF the projector, the value will return to the
original setting.
"000" [CR]
"101" [CR] ----Input-VIDEO
"000" [CR]
"101" [CR] ----Input-VIDEO
"nnnn" is minimum value.
"nnnn" means maximum value.
This result of current Total dots value-Display dots.
Page
19