Canon LV-5200 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Canon LV-5200에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-5200 48 페이지. Canon lv-5200: user guide
Canon LV-5200에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지)

페이지 인쇄
Canon LV-5200 소유자 매뉴얼

CONNECTING THE PROJECTOR

This projector has input and output terminals on its back for connecting computer and video equipment. Refer to figures on
pages 11 to 13 for these connections.
S-VIDEO INPUT JACK
Connect the S-VIDEO
output
from
your
video equipment to
this jack.
(Refer to P13.)
DVI - I
RGB IN-2
RGB INPUT 2 TERMINAL
(DIGITAL/ANALOG)
Connect computer output
(Digital / Analog DVI-I
type) to this terminal.
(Refer to P12.)

TERMINALS OF THE PROJECTOR

AUDIO INPUT JACKS
Connect
the
audio
output from your video
equipment to these jacks.
(Refer to P13.)
G When the audio output
is monaural, connect it
to L (mono) jack.
AUDIO
VIDEO IN
R
L
IN
Y
Pb/Cb
Pr/Cr
AUDIO
S – VIDEO IN
COMPUTER
R
L
OUT
AUDIO IN
RGB IN-1 / OUT
CONTROL PORT
RGB INPUT 1 / OUT TERMINAL
(ANALOG)
This terminal is switchable and
can be used as computer
input or monitor output. Set
the terminal up as either
Computer input or Monitor
output properly before using
this terminal.
(Refer to P12, 36.)
Note:This terminal outputs
analog signal from DVI-I
RGB IN 2 terminal only.
VIDEO INPUT JACKS
Connect the composite video
output from your video
equipment to VIDEO/Y jack
or connect the component
video outputs to VIDEO/Y,
Pb/Cb and Pr/Cr jacks.
(Refer to P13.)
RESET
COMPUTER AUDIO
INPUT JACK
Connect the audio output
(stereo)
from
computer to this jack.
(Refer to P12.)
AUDIO OUTPUT JACKS
Connect an external
audio amplifier to these
jacks.
(Refer to P12, 13.)
RESET BUTTON
The projector uses a micro
processor for control, and
occasionally, need to be reset.
This can be done by pressing
the RESET button with a pen,
which will shut down and
restart the unit.
use the RESET function
excessively.
CONTROL PORT CONNECTOR
When
controlling
computer with the Remote
Control Unit of this projector,
connect the mouse port of
your
computer
connector. (Refer to P12.)
USB CONNECTOR (Series B)
When
controlling
computer with the Remote
Control Unit of this projector,
your
connect the USB port of your
computer to this connector.
(Refer to P12.)
Do not
your
to
this
your
11