Canon LV-5200 소유자 매뉴얼 - 페이지 39

{카테고리_이름} Canon LV-5200에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-5200 48 페이지. Canon lv-5200: user guide
Canon LV-5200에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지)

페이지 인쇄

1. Connecting to Computer

Be sure to reset the Lamp Replace Counter after the Lamp Assembly is replaced. When the Lamp Replace Counter is reset,

the LAMP REPLACE Indicator stops lighting.

Turn the projector on, press the MENU button and the ON-

SCREEN MENU will appear. Press the POINT LEFT/RIGHT

button(s) to move the red frame pointer to the SETTING

Menu icon (refer to page 36, 37).

Press the POINT DOWN button to move the red frame

pointer to "Lamp counter reset" and then press the SET

button. The message " Lamp replace counter reset? " is

displayed. Move the red arrow pointer to [Yes] and then

press the SET button.

Another confirmation dialog box appears and select [Yes] to

reset the Lamp Replace Counter.

NOTE : Do not reset the Lamp Replace Counter until after the Projection Lamp is replaced.

This projector uses a high-pressure lamp which must be handled carefully and properly. Improper

handling may result in accidents, injury, or create fire hazard.

Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no

guarantee of the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a

shorter period of time than other similar lamps.

If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE INDICATOR

lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.

( Follow carefully the instructions in the LAMP REPLACEMENT section of this manual. ) Continuous

use of the lamp with the LAMP REPLACE INDICATOR lighted may increase the risk of lamp explosion.

A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its

lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in

which the projector and lamp are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.

If a lamp explodes, disconnect the projector's AC plug from the AC outlet immediately. Contact an

authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check

carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out

from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one

should check the inside of the projector except those who are authorized trained technicians and who are

familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who

are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken

glass.

LAMP REPLACE COUNTER

LAMP HANDLING PRECAUTIONS

Move the pointer to the Lamp counter reset icon and

then press the SET button. The message "Lamp

replace counter reset?" is displayed.

APPENDIX