Canon LV-7325U 소유자 매뉴얼 - 페이지 24

{카테고리_이름} Canon LV-7325U에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-7325U 48 페이지. Canon multimedia projector owner's manual lv-7325u

페이지 인쇄

COMPUTER MODE

This Projector can automatically tune to the display signals from most personal computers currently distributed.

However, some computers employ the special signal formats which are different from the standard ones and

may not be tuned by Multiscanning of this projector. If this happens, the projector cannot reproduce a proper

image and the image is recognized as a flickering picture, a non-synchronized picture, a non-centered picture or

a skewed picture.

This projector has PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match

with those exceptional signal formats and the projector has five independent memory areas to memorize those

parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use

it.

Note : This PC ADJUSTMENT function cannot be operated when "RGB," "HDTV1035i" or "HDTV1080i" is selected on the

SYSTEM MENU (P23 and 26).

Press the MENU button and the ON-SCREEN MENU will

appear. Press the POINT RIGHT/LEFT buttons to select PC

ADJUST

box "Where to reserve" Menu will appear.

In this dialog box, you can store the parameter into the area

from "Mode 1" to "Mode 5." When memorizing the new

computer parameter, select the Mode with the message of

"Free" by pressing the POINT UP/DOWN buttons and the

SELECT button. To change the parameters of the Mode

previously set, select the Mode with "Stored."

When the Mode is selected, Parameter adjustment dialog box

appears. Move the arrow to the item that you want to change

by pressing the POINT UP/DOWN buttons, and adjust each

item to match your computer. To change the value, press

either the POINT RIGHT button or the POINT LEFT button.

Refer to the next page for adjusting each item.

Move the arrow to "Stored" and press the SELECT button. The

parameter is memorized in the selected Mode.

To activate the Mode manually adjusted in this PC

ADJUSTMENT Menu, select the Mode at the SYSTEM

SELECT Menu. (Refer to page 23.)

PC ADJUSTMENT

and press the SELECT button. Another dialog

This Mode has para-

meters being stored.

The Vacant Mode.

Manual set Computer

Mode (1 to 5).

Close the PC

ADJUSTMENT Menu.

Press the POINT

RIGHT/LEFT

button(s) to

adjust the value.

Press the

SELECT button

to set Full screen

function on/off.