Canon LV-7555 사양 - 페이지 23
{카테고리_이름} Canon LV-7555에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-7555 24 페이지. Svga & xga models
Canon LV-7555에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지)
페이지 인쇄
MR3P
Series Basic Serial Command Function Specification
‚ T .8.10 "04" [CR]
Status of Power Save
The status is Power Save by the Power management function in setting
menu.
Control commands as below are available in this status.
‚ T .8.11 "21" [CR]
Automatically turning off due to a lamp failure (During cooling down).
When a lamp failure occurs, projector will start cooling down automatically.
The return command is "21" [CR]. During processing cooling down, the
command, "21" [CR] stays.
‚ T .8.12 "81" [CR]
Stanby status after recovering lamp failure.
This is the return command after cooling down and moving on to
standby status.
The Stanby status stays until next command is issued.
In short, when executes Power On, the lamp information is cancelled
and projector performs as usual.
‚ T .9
Input Mode Read Command
Command
"CR1" [CR]
Detail
Get selected Input No.
Acceptable
Response
Unacceptable
‚ T .10
Lamp Time Read Command
Command
"CR3" [CR]
Detail
Get total lamp running hours
Acceptable
Response
Unacceptable
"%1" [CR]
"1" = Input1is selected
"2" = Input2is selected
%1
"3" = Input3is selected
"4" = Input4• i Network Viewer• j is selected
"• H " [CR]
"%1" [CR]
Show as 4 digits
%1
Ex.• F "0410"[CR] ¥ ¥ ¥ ¥ 4 10 hours
"• H " [CR]
Soft Engineer Division
Page
23 / 24