Canon LV-8300 사용자 설명서 - 페이지 5

{카테고리_이름} Canon LV-8300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-8300 25 페이지. Lv-series multimedia projectors
Canon LV-8300에 대해서도 마찬가지입니다: 제품 설명서 (18 페이지), 시작 설명서 (6 페이지), 브로셔 및 사양 (4 페이지)

페이지 인쇄

1. Troubleshooting

C14

Configuring the Network Settings of the Software

When installation of this software is complete, run the software and configure the discovery

settings of the network for discovery.

1.4.1

Starting the Software

Click the Windows [Start] menu and select [All Programs], followed by

[Projector Monitoring Software] and [Projector Monitoring Software].

Main screen of this software will display.

1.4.2

Configuring the Discovery Settings

Configure the network range for discovering projectors. Methods vary depending on "SNMP

V1/V2c/V3" and "LV Series". Configure each protocols respectively.

■

For SNMP V1/V2c/V3

When using "SNMP V1" / "SNMP V2c" / "SNMP V3", you can specify a broadcast address or

IP address range for discovery. Select a protocol type and configure the range for discovery.

Configure SNMP V1/V2c/V3 with the following procedures. Configuration can be done with

the same procedures. SNMP V3 is used in this example.

From [Discovery settings] of the [Option] menu, select a name of protocol

([SNMP V1] / [SNMP V2c] / [SNMP V3]) to configure.

[Discovery settings] dialog will display.

Place a checkmark in [Enable (Protocol Name)].

Remove a checkmark if protocol is not used for discovery.

CHAPTER 1 • Introduction