Canon LV-S1 소유자 매뉴얼 - 페이지 36

{카테고리_이름} Canon LV-S1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-S1 44 페이지. Micro-portable multimedia projector
Canon LV-S1에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지)

페이지 인쇄

SETTING

Power management

This function turns Projection Lamp off when this projector detects

signal interruption and is not used for a certain period in order to

reduce power consumption and maintain the Lamp-life. (This

projector is shipped with this function ON.)

Power Management function operates to turn Projection Lamp off

when the input signal is interrupted and any button is not pressed

over 5 minutes. This function operates as follows;

1. When any input signal is interrupted, "No signal" and the

counting down display appears (for 5 minutes).

2. When Projection Lamp is turned off, READY Indicator is turned

off. Cooling Fans operate and Projection Lamp is turned off for

90 seconds. (During this "Cooling Down" period, projector

cannot be turned on.)

3. When Projection Lamp has cooled down, READY Indicator

flashes and Projection Lamp can be turned on again (Power

Management mode).

In this Power Management mode, Projection Lamp is

automatically turned on when the input signal is connected or

projector is operated with any button on Top Control or on

Remote Control Unit again.

Remote control

This projector has two different remote control codes; the factory-set

normal code (Code 1) and the secondary code (Code 2). This

switching function prevents remote control operation mixture (jam)

when operating several projectors or video equipment together.

When operating projector in "Code 2," both projector and Remote

Control Unit must be switched to "Code 2."

To change the code of Projector;

Set Remote control in the SETTING MENU to "Code 2."

To change the code of the Remote Control Unit;

Press both MENU and IMAGE buttons on Remote Control Unit

together for over 10 seconds.

After changing the code, make sure Remote Control operates

properly.

To return to the normal code (Code 1), operate both projector and

Remote Control in the ways above again.

NOTE : When battery of Remote Control Unit is replaced, the remote

control code automatically returns to the normal code (Code

1).

Lamp counter reset

This function is used to reset Lamp Replace Counter. When

replacing Projection Lamp, reset Lamp Replace Counter by using

this function. Refer to page 38 for operation.

Time left until Lamp off.

Move the pointer to Lamp counter reset and then press

SET button. The message "Lamp replace counter

reset?" is displayed.