Canon LV-S2 소유자 매뉴얼 - 페이지 39
{카테고리_이름} Canon LV-S2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-S2 44 페이지. Micro-portable multimedia projector
Canon LV-S2에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지)
페이지 인쇄
The WARNING TEMP. Indicator flashes red when the internal temperature of the projector exceeds the normal temperature.
This Indicator stops flashing when the temperature of the projector returns to normal.
When the WARNING TEMP. Indicator continues to flash, check the items listed below.
1
The Ventilation Slots of the projector may be blocked. In such an event, reposition the projector so that the Ventilation
Slots are not obstructed.
2
The Air Filter may be clogged with dust particles. Clean the Air Filter by following section AIR FILTER CARE AND
CLEANING below.
3
If the WARNING TEMP. Indicator remains on after performing the above checks, the Cooling Fans or the Internal
Circuits may be malfunctioning. Contact service personnel from an authorized dealer or a service station.
The Removable Air Filter prevents dust from accumulating on the surface of the Projection Lens and the Projection Mirror.
Should the Air Filter become clogged with dust particles, it will reduce Cooling Fans' effectiveness and may result in internal
heat build up and adversely affect the life of the projector. Clean Air Filter following the steps below:
1
Turn off the projector, and disconnect the AC power cord from
the AC outlet.
2
Turn the projector upside down and remove the two Air Filters
(Large and Small) by pulling the latches upward.
3
Clean the Air Filters with a brush or wash out dust and particles.
4
Replace each Air Filter properly. Make sure that the Air Filters
are fully inserted.
CAUTION
Do not operate the projector with the Air Filter removed.
Dust may accumulate on the LCD Panel and the Projection
Mirror, therefore degrading picture quality.
Do not put small parts into Air Intake Vents. It may result in
malfunction of the projector.
RECOMMENDATION
We recommend avoiding dusty/smoky environment when operating a projector. Usage in these environments may
cause poor image quality.
When using under dusty or smoky conditions, dust may accumulate on the lens, liquid crystal panels, or optical elements
inside the projector. This condition may degrade the quality of a projected image.
When the above symptoms are noticed, contact your authorized dealer or service station for proper cleaning.
Follow these steps to clean the Projection Lens:
1
Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.
Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.
2
Lightly wipe a cleaning cloth over Projection Lens.
3
When the projector is not in use, attach Lens Cover.
MAINTENANCE
WARNING TEMP. INDICATOR
AIR FILTER CARE AND CLEANING
CLEANING PROJECTION LENS
AIR FILTER(Small)
AIR FILTER(Large)
39