Canon LV-X2 소유자 매뉴얼 - 페이지 15
{카테고리_이름} Canon LV-X2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon LV-X2 44 페이지. Svga & xga models
Canon LV-X2에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 브로셔 및 사양 (2 페이지)
페이지 인쇄
Point Remote Control Unit toward projector (Receiver
Window) whenever pressing any button. Maximum
operating range for Remote Control Unit is about 16.4' (5m)
and 60° in front of the projector.
REMOTE CONTROL UNIT BATTERY INSTALLATION
1
Pull out Battery Holder.
To insure safe operation, please observe the following precautions :
G Use only specified battery. Improper battery may cause malfunction of Remote Control Unit.
G Be sure to install battery with correct polarity.
G Do not expose a battery to moisture or heat. Do not charge a battery.
G If a battery has leaked on the Remote Control Unit, carefully wipe the case clean and load a new battery.
G Keep a battery away from children to avoid swallowing it accidentally.
G Risk of explosion if battery is replaced by an incorrect type.
G Dispose of used batteries according to the instructions.
OPERATING RANGE
Replace with new battery. Install
2
with battery (+),(–) marks properly.
Put Battery + mark
as shown direction.
BATTERY HOLDER
16.4'
(5 m)
30°
30°
Install battery and
3
Battery Holder into
Remote Control Unit.
BATTERY
LITHIUM BATTERY
CR2025 (3.0V)
BEFORE OPERATION
(+) mark indicates
its (+) polarity.
15