Canon WUX7500 매뉴얼 - 페이지 18
{카테고리_이름} Canon WUX7500에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon WUX7500 29 페이지. Lcos projector
페이지 인쇄
（ 2 ） Cables and Transmission Distance
HDBaseT connections may be subject to transmission distance limitations depending on the type of network
cables and transmitters used.
Below is an actual example of what happened when a certain transmitter was used.
Band width
(example of
signal)
Cable type
Transmitting
distance
As shown here, adequate transmission distance for handling signals with large amount of data may not be
attainable depending on the combination of the equipment and cable used. We recommend that shielded cables
be used.
（ 3 ） Image Signal Quality
Because of the structural nature of the network cable, an HDBaseT signal is transmitted in parallel over four
physically separated transmission lines.
Each transmission line has a stability index value [dB]. This product detects the four values and calculates the
total.
Based on this value, the product judges the quality as follows.
Index
100-60
59-40
39-0
（ 4 ） Network via HDBaseT
There is essentially no difference in the communication quality as compared to a normal network.
NMPJ can be used in the same manner.
（ 5 ） Settings and stand-by power consumption
The standby power varies depending on the settings of serial communication, standby power setting and
network settings as follows:
Wired network
On
Off
** When wireless network is set to "On", the standby power is set to "Normal".
(18/28)
1.65Gbps or more
(1080p/60 @12bit)
CAT5e
70ｍ
Display
(color)
Green
Use recommended
Yellow
Use not recommended
Red
Not usable
Standby power setting
Normal
Low power
-
CAT6／CAT7
Transmitting
100ｍ
Judgment
Serial communication
Service port
HDBaseT
Service port
HDBaseT
Service port
HDBaseT
Under 1.65Gbps
(1080p/60@8bit,1080p/24@12bit)
Cable type
distance
Standby power
(Not disclosed)
(Not disclosed)
1.6 W
1.6 W
0.28 W
1.5 W
CAT5e
70ｍ