Dorma ESA II 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Dorma ESA II에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dorma ESA II 2 페이지.
Dorma ESA II에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지)

DORMA

7 Lock adjustments.

Lock type and Locking program are not learned and should be adjusted on each installation.

adjusting the Locking will result in an opening hesitation.

Lock Type: press the Select button once and a menu level letter will appear in the display. Press the up or down

buttons until an L. appears. Press Select again and a number will appear. Using the up and down button select one

of the following, 0 for no lock or 2 for the Bistable lock with NO contact.

Lock Program: press the Select button once and use the up and down button until the r. is displayed, Press the

Select button again then use the up and down buttons to select 0. for lock in Off or 1. for Off and Exit Only.

8 Final Adjustments use the Select and Up and Down buttons to make any final adjustments to the following A.

backup battery, o. night bank hold open, d. hold open, O. opening speed and C. closing speed.

9 Trouble shooting.

The two Led's indicate the state of the two presence sensors inputs and both must be on in order for the door to

close. Before each closing cycle the safety sensors are tested and you will notice the lights blink before the door

closes. If either light is out it indicates a problem with the related presence sensor.

Both the low voltage and motor circuits are protected from short circuits. In the event of a short circuit the controls

shuts the affected circuit off. Once the short circuit is removed the control will restore power.

The control keeps a log of errors to access this log press the Select button once and use the up and down buttons

to set the display to E. then push the select button again and using the up button check the error log for faults.

0 no error, 1 obstruction, 2 lock, 3 program switch, 4 safety beam, 5 encoder, 7 system, 8 emergency stop, 9 learn

error, A motor fault, b battery test error, c force test, d over current.

DORMA AUTOMATICS, Inc.

ESAII CONTROLER

Quick Start

924 Sherwood Drive

Lake Bluff, IL 60044

DL0000-000

Toll-Free: 877-367-6211

8/25/2009

Fax: 877-423-7999

Subject to change without notice

Adjust Lock setting on

Not

all installs.

Led's must be on for

door to close.

Review Error Log,

before calling technical

assistance.

2 of 2