Canopus ADVC-700 매뉴얼 사용 방법 - 페이지 7

{카테고리_이름} Canopus ADVC-700에 대한 매뉴얼 사용 방법을 온라인으로 검색하거나 PDF를 다운로드하세요. Canopus ADVC-700 9 페이지. Analog-digital converter media rack

IV. Digital Video Processor (Input/Output #6)

This component converts between different video formats — NTSC, PAL, SECAM.

From analog sources to the computer:

If you want to capture a few minutes from a non-NTSC VHS onto the computer's hard

drive, you'll have to loop the signal through the video processor. Though iMovie says it's able to

import PAL and NTSC alike, this seems not to be true for material from VHS.

A) Set up your tape, and patch the signal to the video processor.

B) The video processor itself is rather difficult to figure out, so a few presets have

been added to make things easier.

C) To choose a preset:

1. Turn on the processor and wait until the small screen on the right no longer

reads "11."

2. Hit "Recall." The button will flash red — this is normal.

3. Using the +/- buttons, choose a preset (in this case, 1 or 2).

4. Hit the "Recall" button again. The settings should now be correct.

If you've chosen Preset 1, the display will look like this:

(The middle buttons have been cut out and replaced by a dotted line — this is because they are

very confusing and not particularly useful.)

D) Now you have to send the signal from the processor into the analog-digital converter

and into the computer.

Output 7 > Input 6

You're ready to capture.

Output 6 > Input 3

Preset 1 converts PAL B to NTSC

Preset 2 converts SECAM to NTSC

How to Use the Media Rack - 7