Canor AI 2.10 사용자 설명서 - 페이지 5
{카테고리_이름} Canor AI 2.10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canor AI 2.10 6 페이지.
페이지 인쇄
Basic functions of reproduction
Plug the power cord in AI 2.10. Turn on the AI 2.10 with the Power Main switch, which is located on the back
panel. When you turn on the main switch, the AI 2.10 will set into stand-by mode - the red LED diode on the
front panel lights up. After pressing the Power button (on the front panel or on the remote control) controlled
turning-on sequence gets initiated, which consists of cooling and preheating the tubes, thereby extending their
life span. The cooling cycle is also being carried out when the unit is turned off, if the main switch on the back
panel is not turned off, i.e. after turning off via button on the front panel, or via remote control, and 45-second
countdown to cooling without indication begins. If you turn on the unit at this time, the cooling will continue and
will be indicated by flashing red LED. When the cooling cycle is over then the main toroidal transformer gets
connected (the CANOR logo lights up), and then the slow start-up of voltage begins.
This cycle lasts 45 seconds and then the red LED stops flashing , an output relay connects the signal to the last
selected input if the main power supply does not get diconnected.
During the first turning on or disconnecting the main power supply IN1 input gets preselected and the volume
level is set to -44dB. Volume is being set in 63 steps by 1dB. The highest volume is 0dB, the lowest being -
63dB. Another step is MUTE. You can control the volume with a big control knob on the front panel. The
volume is being controlled by a relay attenuator with an accuracy of concurrence better than 0.05dB.
You can connect both 4 and 8 Ohm loudspeakers.
Specificatons :
Output power:
Input sensitivity:
Frequency range:
Input impedance:
RCA Inputs:
XLR Inputs:
Total Harmonic Distortion:
Signal-to-noise ratio:
Tube Complement:
Power:
Dimensions (WxHxD):
Weight:
Guarantee conditions:
Your CANOR AI 2.10 integrated tube amplifier is guaranteed against any defect in materials and workmanship
for a period of 24 months from the date of purchase except for audio vaccum tubes that are covered by warranty
for a period of three months.
The warranty only applies if an original proof of purchase and acknowledged certificate of warranty can be
furnished. The warranty covers defects in materials and labor, but does not cover misuse, unauthorized
modifications, and external causes such as acts of nature.
2 x 150W / 4 Ohm
400mV / 150W / 1kHz
20 - 20 000Hz +/-0,3dB / 5W
30 kOhm
4 RCA
2 XLR
<0,02% / 1kHz , 5W
95dB
2 x 6922
230V / 50Hz / 460VA
435 x 120 x 405 mm
17 kg