Dormakaba ORACODE 480 Series 설치 매뉴얼 - 페이지 2
{카테고리_이름} Dormakaba ORACODE 480 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dormakaba ORACODE 480 Series 5 페이지.
Dormakaba ORACODE 480 Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (10 페이지)
페이지 인쇄
KEY OVERRIDE CYLINDER
4
If cylinder is not already assembled in the lock,proceed as follows:
1. Remove 4 screws
2. Remove back plate
Install key cylinder
May be necessary to
loosen post to remove
back plate
5
ADJUST LOCK HANDING ON OUTSIDE HOUSING ASSEMBLY
Right hand (RH)
"Retaining ring"
opening at 12 o'clock
"Wire ring" opening far
Groove at 6 o'clock
from slot
6
7
ASSEMBLE TAIL PIECE
REMOVE INSIDE COVER
Click in place
PK3700 2018-06-29
Override Switch
4. Wire must not be pinched
when re-installing back plate
5. Re-assemble back plate using
screws as shown
If required, re-tighten post
while making sure not to
pinch retaining ring
WARNING
Posts are mandatory for Fire
Certification and should never
be removed.
Left hand (LH)
Slot
Rotate to change
Hold from rotating
Groove at 12 o'clock
from RH to LH
8
ASSEMBLE OUTSIDE HOUSING
Remove tape
Run cable through door
and under the dead bolt
9
INSTALL INSIDE TRIM ASSEMBLY
Slot
1. All screws should be tightened properly
2. Connect batteries after tightening all screws
10
INSTALL INSIDE COVER
Run cable through inside
trim back plate slot
3
2
1
Connect W1 to W2 (Communication)
Connect V1 to V2 (Power)
Use short 8-32 screws on door thickness
1 3/8" ≤ THK ≤ 1 11/16"
Use Long 8-32" screws on door thickness
1 11/16" < Thk ≤ 2.0"
Use short 6-32 screws on door thickness
1 3/8" ≤ THK ≤ 1 11/16"
Use long 6-32" screws on door thickness
1 11/16" < Thk ≤ 2.0"
Use short 12-24 screw for thickness
≤ 1 3/4 (using the long screw for door
≤ 1 3/4 will damage the mechanism)
V2
V1
W1
Page 2 of 4