Akyga AK-CA-73 사용자 설명서 - 페이지 4

{카테고리_이름} Akyga AK-CA-73에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Akyga AK-CA-73 6 페이지.

AK-CA-73 - user manual

Connecting fans and LED strips to the controller

1. Make sure that the current consumption of the fans and LED strips does not esceed the

maximum allowable load for the controller.

2. Make sure that the controller is not connected to a power source.

3. Select and connect the appropriate 6-pin plug from the fan to the 6-pin socket on the controller.

4. Connect up to two LED strips with the corresponding 4-pin connectors to the 4-pin sockets of

LED STRIP 1 and/or LED STRIP 2.

Connecting controller to power supply

1. Make sure that the power supply is disconnected from power source.

2. Connect cable included in the kit. The 4-pin connector should be plugged into the POWER

socket in the controller. The Molex connector should be plugged into the corresponding socket

on the ATX power supply.

3. Optional: connect the 2-pin SW button connector from the case front panel to the 2-pin

connector on the controller.

4. Peel off the strip securing the double-sided tape on the back of the controller.

5. Attach the controller to the chosen location in the case.

6. The controller is ready to use.

Rekomended:

Akyga AW-12D-RGB

OPTIONAL

POWER SW

MAIN BOARD

SUPPLY FROM

MOLEX SOCKET

RGB LED Strip

5V 4 pin

p. 4