Cansec MAP1 구성 - 페이지 8

{카테고리_이름} Cansec MAP1에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cansec MAP1 12 페이지.

5. Insert the power connector into the MAP1 controller. The unit will begin the power up

sequence which takes about 30 to 40 seconds. When complete, the MAP1 controller

will beep indicating its mode e.g. First Access, Webster or CloudACS.

6. Remove the USB flash drive from the MAP1 controller.

7. Insert the flash drive into a USB port on a computer. When ready, launch Windows

Explorer or File Explorer. Access the USB drive and edit the file named MAPCFG.txt

is not present, repeat from step 1. Otherwise proceed to step 8.

8. A similar file will be

displayed when

opened in Notepad.

created by the MAP1 controller during boot-up sequence. If the file

MAP1 IP Configuration

Page 8 of 12

July 2021 • Rev. 1.2