Cansec VIA 설치 매뉴얼 - 페이지 4
{카테고리_이름} Cansec VIA에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cansec VIA 10 페이지. Universal wireless lock
Cansec VIA에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지)
페이지 인쇄Configure Via Hub
D32 (BLUE)
Figure 2: Configure Via Hub Unit
DIP SWITCHES
DIP SWITCH "A" - ADDR
Do not change the default settings:
Switch A1 sets to DOWN (ON), switches A2-A8 set to UP (OFF).
ON
DIP SWITCH "B" - NET ID
Switches B1-B6 are used to set a Network ID which can be from 1 to 63 and must match the Net-
work ID of the Via Lock Control Unit (See figure 3 for typical Net ID configurations). Do not
duplicate Via Hub Network IDs unless they are well out of the range of each other (500 feet should
be safe). Switches B7 & B8 set to OFF (UP) for future use.
Set the Network ID according to the table below:
D35
C
(WHITE)
ON
D23 (RED)
D20 (GRN)
A
D E
B
D26
D27
D31
D30
Configuration Manual
ON
ON
ON
Via Hub
Page
4
of
10
July 2017 • Rev. 1.1