Advance acoustic 9087266020 사용 설명서 지침 - 페이지 20

{카테고리_이름} Advance acoustic 9087266020에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Advance acoustic 9087266020 20 페이지.

ENGLISH

MACHINE OPERATION (SCRUBBING/DRYING)

Start the machine as shown in the previous paragraph.

If necessary, adjust the solution quantity by pressing the switches (59 and 60).

If necessary, to reduce the noise, turn on the mute function by pressing the switch (55).

NOTE

It is suggested to use the mute function only on smooth ﬂ oors without joints.

NOTE

For correct scrubbing/drying of ﬂ oors at the sides of the walls, Advance suggests to go near the walls with the right side

of the machine as shown in ﬁ gure 3.

Squeegee adjustment

If necessary, stop the machine and turn the squeegee balance adjusting handwheel (35) so that the rear blade - in all its length

- touches the ﬂ oor.

Adjustment of the detergent concentration in the solution

(For machine with EcoFlex™ system)

The system used to mix the detergent with the washing water can be activated by pressing the detergent ﬂ ow control switch (A, Fig.

4): when the LED (B) is on, the detergent is added to the washing water.

The display (C) shows the detergent concentration level in the solution as shown in the table in Figure 5.

NOTE

The detergent concentration in the solution dispensed from the system always corresponds to level 1. In order to

temporarily obtain a stronger concentration, press the EcoFlex™ switch or disable the EcoFlex™ system (see the

relevant paragraph).

EcoFlex™ function

Lift the EcoFlex™ lever (D, Fig. 4) whenever a stronger washing power is required.

When lifting the lever (D) (LED (E) ﬂ ashing) the solution ﬂ ow increases, the extra pressure function activates (for machines with

EcoFlex™ system) and the detergent concentration in the corresponding solution rises to the set level (moreover, if the detergent

mixing function is not activated, it activates automatically).

The original settings can be restored by lifting the lever (D) once again (LED (F) on).

NOTE

If the lever (D) is not lifted once again, the original settings are restored automatically after 60 seconds.

In order to change the actual detergent concentration, proceed as follows:

Turn off the detergent ﬂ ow control switch (A) (the LED (B) must be OFF).

Press and hold the detergent ﬂ ow control switch (A) until the LED (B) ﬂ ashes.

Release the switch (A). Press it again shortly to go to the next level shown by the display (C) as shown in the table in Figure 4;

repeat the procedure until the desired setting is reached.

Wait until the LED (B) stops ﬂ ashing: the new level is now set.

NOTE

Detergent percentage setting is stored into memory, even if the machine is turned off.

INSTRUCTIONS FOR USE

9098827000(2)2010-12

Figure 3

SC3000 26" Disc / 28" Cyl.

P100364