Dormakaba MUTO Premium 설치 지침 - 페이지 5
{카테고리_이름} Dormakaba MUTO Premium에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dormakaba MUTO Premium 8 페이지. Integrated locking device
페이지 인쇄
dormakaba Montageanleitung
Mounting instructions
5.2
Procedure for wall switch BRC-W
Fig. 6
Wall switch BRC-W
Carry out the following points (1 – 3) within
20 seconds, otherwise the teach-in mode is
automatically terminated
1.
Briefly press the teach-in button on the
transmitter. Do not press the transmitter's touch
surface.
‣
The transmitter's device LED flashes green.
2. Press the transmitter's touch surface.
‣
The device LED flashes orange.
3. Press the locking device's teach-in button for
more than 4 seconds.
‣
The locking device LED flashes red briefly; the
transmitter LED flashes green for 3 seconds.
The devices are connected.
‣
The device LED lights up red for 2 seconds;
the transmitter LED lights up red for
3 seconds. Teach-in has failed: reset
programming and repeat teach-in.
4. Check locking device function with door in closed
position.
To connect additional transmitters to the locking
device, repeat steps 1 – 4.
6
Manual locking/unlocking (directly on
the control unit)
The locking device can be operated manually
independently of the hand-held transmitter or wall
switch. If this is required, briefly press the teach-in
button (see Chapter 3.4) once.
MUTO Comfort / Premium
7
To reset the programming, delete the transmitter and
receiver data (locking device).
Procedure for transmitter and receiver (locking
device):
1.
To cancel the reset, briefly press the teach-in button
again. The slow red flashing stops.
2. Press the teach-in button for more than 4 seconds
• flashes red briefly when it is locked,
• flashes red for 3 seconds on the BRC-W or
• the red LED goes out on the BRC-H.
8
If an error has occurred, perform a function test.
1.
The radio transmitter's function is restored (see the
radio transmitter's flashing codes).
If the device is not ready for use afterwards, this is
due to the duty cycle being exceeded (see Chapter 3.6
Flashing codes and Chapter 3.7 Warning thresholds).
The control unit is unaffected by the duty cycle.
9
• At least 2 years maintenance-free operation
• Replace damaged components immediately
• Only use original dormakaba parts
WN 058855 45532
Manual locking/unlocking (directly on the control unit)
Reset programming
Press the teach-in button for more than 4
seconds.
‣
The device LED flashes red slowly.
again.
‣
The device LED starts flashing red more
rapidly.
‣
When you release the teach-in button, the
device LED
→ The transmitter and receiver are reset.
Perform a function test
If necessary remove the batteries and replace
them with new batteries.
Maintenance and care
(at 10 operations per day)
2020-03
5