Canton Reference 2 매뉴얼 - 페이지 4

{카테고리_이름} Canton Reference 2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canton Reference 2 8 페이지.

English

OPERATING NOTES

Canton speakers are suitable with amplifiers with high output power, even if this is higher than the power handling specified in the technical

data of the Canton speaker. In fact, a danger to the loudspeaker comes rather from low-power amplifiers, since they are overdriven when

trying to generate more sound pressure by "turning up" volume and tone controls. Distortion can be generated by so-called "clipping",

which can destroy the tweeters of the loudspeakers in particular. Therefore, please pay attention to distortions when adjusting the volume

and reduce the volume immediately if necessary.

Attention:

Floorstanding loudspeakers have a high center of gravity and can easily tip over if they are not set up correctly or if they are moved

abruptly. It is the user's responsibility to avoid this.

Further notes

Intended use:

The speaker system is designed for indoor use and must not be used outdoors or in wet environments. The device must not be

altered or modified. Connect the device as described in the instructions and observe the safety instructions. Load the device with

the maximum input power specified on the type plate.

Electrical and electronic equipment placed on the market within the European Union must bear a CE mark to indicate that the

equipment complies with the applicable requirements (e.g. on equipment safety or electromagnetic compatibility).

In accordance with the EU Directive on Waste Electrical and Electronic Equipment, devices marked with this symbol must not be

disposed of with household waste. If necessary, please contact your local waste disposal company or the municipal/city adminis-

tration for information on how to dispose of this equipment free of charge. It serves the protection of the environment and health

as well as the saving of (rare) raw materials through reuse (recycling).

CONNECTING THE SPEAKERS

On the back of your Reference speakers you will find the connection terminal. This terminal is used to connect your Reference speaker

to the amplifier. When connecting the speakers, be sure to observe the correct polarity. Plus to plus and minus to minus. Both the screw

terminals of the loudspeakers (plus pole = red, minus pole = white) and the connections of the control unit are marked with corresponding

symbols or colors. For easier orientation, the wires of most speaker cables also differ by color, shape or imprint. Different polarity between

the left and the right channel lead to sound distortions and audible cancellations in the bass range. For a better understanding, please

also consult the operating instructions of your control unit.

In order to develop its maximum performance, a loudspeaker requires a break-in period of approx. 15-20 operating hours. During this time,

the properties of many mechanical components change until they reach the values specified during the development of the loudspeaker,

i.e. the suspension of the chassis becomes more flexible and the reproduction quality is positively influenced.

Notes:

• Please make sure to use high quality speaker cables. Inferior cables can negatively affect the sound quality of your speakers and thus

the sound experience.

• For the left and right channels, the speaker cables should ideally be about the same length. Speaker cables of different lengths can

lead to a difference in volume between the two channels.

• Please ensure that the speaker cables have a sufficient cross-section (min. 1.5 mm

section have a higher line resistance, which can impair the sound experience.

Attention:

Before connecting the speakers, switch off all components of your system, but at least the (power) amplifier(s).

English

). Speaker cables with a very small conductor cross-