Asus Tinker Boars S 사용자 설명서 - 페이지 9
{카테고리_이름} Asus Tinker Boars S에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus Tinker Boars S 12 페이지.
페이지 인쇄
- 1. Table of Contents
- 1. 1 Basic Requirements
- 2. 2 Getting Started
- 2. Setting up Using Emmc (Tinker Board S Only)
- 2. Setting up Using a Microsd Card
- 3. 3 Writing the os Image
- 3. Using Etcher (Cross-Platform)
- 3. Using DD Command (Linux)
- 4. 4 OS Write Recovery (Tinker Board S Only)
- 4. Rewriting the os Using UMS from Emmc
- 4. Rewriting the os Using UMS from a Microsd Card
3.2
Using dd command (Linux)
To write an image using dd command:
1.
Insert a microSD card to your Tinker Board (or Tinker Board S),
or
connect your Tinker Board S to a PC via a micro USB cable (Tinker Board S only).
Please refer to your Tinker Board product manual for the location of the microSD slot.
2.
Run the following command:
dd bs=4M if=/path/to/tinkeros.img of=/dev/sdx
Replace /dev/sdx with your drive, e.g. /dev/sdc.
Do not append a partition number to your drive name, for example /dev/sdc1.
Use the lsblk command to find the drive name of your device. Make sure that no partition of the
device is mounted.
3.
Only remove the microSD card or disconnect the Tinker Board S from the PC once
the command sync is completed to ensure the data was written completely.
9