Akytec ITP11-R-W 매뉴얼 - 페이지 2

{카테고리_이름} Akytec ITP11-R-W에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Akytec ITP11-R-W 2 페이지.

페이지 인쇄

Fig. 4 Connection from the right

Fig. 7 Wire preparation

Fit the stranded wire with a wire end ferrules

Maintenance

The maintenance includes:

–

cleaning the housing and the terminals from dust, dirt and debris

–

checking the fastening of the device

–

checking the wiring (connecting leads, fastenings, mechanical damage)

The device should be cleaned with a damp cloth only. No abrasives or solvent-containing cleaners may be used.

ITP11-W_0129_EN

Fig. 8 Connecting the wire to the

Programming

Fig. 10 Flowchart

Wiring diagrams

Fig. 5 Connection from the left

Wire connection

terminal

Press the actuation lever and the contact is opened

Conversion functions

linear function

square root function

where

T – displayed value corresponding to input signal I, mА

di.Lo – Lower limit, corresponds to 4 mA

di.Hi – Upper limit, corresponds to 20 mA

Display messages

Display

With particular setting parameters the device cannot actually

display the necessary 5 figures due to the restriction to four

segments.

Example

The parameters are configured as follows:

With an input measured current of 20.8 mA the correct display

should be "10548". Due to the restriction to four segments, the

first character is removed and the display is "0548".

akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany

Fig. 6 Two side connection

(terminals 1, 4 or 2, 3)

Fig. 9 Disconnecting the wire

Operation









Input current lower than 3.8 mA

Input current higher than 22.5 mA

Upper menu line has been reached

Lower menu line has been reached

No input signal

not lit

Polarity reversal

-999  4 mA

di.Lo:

9999  20 mA

di.Hi:

Tel.: +49 (0) 511 16 59 672-0 ·

















Cause