Canyon Creekside 3899503P 조립 지침 - 페이지 3

{카테고리_이름} Canyon Creekside 3899503P에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Canyon Creekside 3899503P 4 페이지. Full/full bunk bed

BOTTOM BUNK BED

1.- ASEMBLE

2.- INSERT TWO CROSS DOWEL NUTS (G) IN ACCESS HOLE INSIDE THE SIDE RAIL, ALIGN CROSS DOWEL NUT MAKE SURE THE GROOVE IS HORIZONTAL,

3.- ATTACH TWO SIDE RAILS TO BOTTOM HEADBOARDS, INSERTING TWO 4" HEX TAP BOLTS (F) IN EACH CORNER OF BOTTOM HEADBOARD HOLES, USE 5MM ALLEN WRENCH

(H) TO TIGHTEN BOTH HEX TAP BOLTS,

4.- REPEAT THE SAME PROCESS ON ALL FOUR CORNERS.

5.- PLACE FULL SLAT ROLL (I ) INSIDE THE BOTTOM BUNK BED PUSH SLAT PACK AGAINST THE BED END POST

SEE FIG.9

SLAT,

6.- INSERT ONE METAL DOWEL PIN (C) IN EACH BOTTOM HDBD TOP HOLES

METAL DOWEL PINS WITH EACH PRE-DRILLED HOLE IN BOTH ENDS UNTIL THE METAL DOWELS PIN ARE ALL IN,

BOTTOM HEADBOARD

ASSEMBLY

FIG.8

YES,

HORIZONTAL

GROOVE

FIG.A

REV 03 05/09/2019

CANYON FURNITURE COMPANY

BOTTOM HEADBOARD ASSEMBLY (USE FULL SLAT ROLL 100-647)

BY USING TWO BOTTOM HEADBOARDS (B), AND TWO SIDE RAILS (D).

(DO NOT TIGHTEN COMPLETELY UNTIL ALL PIECES ARE CONNECTED TOGETHER)

(FIG.I)

MAKE SURE ALL BOLTS

ARE TIGHTENED

COMPLETELY

FIG.I

, WITH HELP PLACE IT ON TOP HDBD ASSEMBLY ON TOP BOTTOM HDBD ASSEMBLY ALIGNING

FIG.B

PAGE 3 OF 4

(FIG.B)

AND SECURE WITH TWO 1 1/4" SCREWS (J ) IN EACH

SEE FIG.10

O.- (4) METAL CASTER SOCKET

J.- (6) 1 1/4" SCREW

CASTER TWIN BED BOX ( 90-707,90-709 )

SEE FIG.A

SEE FIG.8

FIG.9

FIG.10

KIS01164-0