Advance Appliances EG9-U 설치 및 사용자 설명서 - 페이지 5

{카테고리_이름} Advance Appliances EG9-U에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Advance Appliances EG9-U 12 페이지. Electric boiler 6, 9 & 12kw

INSTALLATION SCHEMATICS

SEALED SYSTEM

Sealed System Kits are available from

Advance Appliances and can be sited

anywhere in the open pipework of

the system

The eGlow boiler can only be configured into a sealed system. A sealed system kit can be

purchased from Advance Appliances to make the job simple. An 8 litre expansion vessel is

supplied with each kit but it should be noted that systems with high water content may

require larger vessels. All heating systems must be isolated from the mains water supply

after the system is filled.

THIS APPLIANCE MUST BE EARTHED

The appropriate current regulations and best practices must always be followed. Installation

must be carried out by a competent and qualified tradesman. Use off peak supplies where

possible to reduce running costs.

Check the incoming supply meets the minimum requirements of the appliance and utilise a

double pole RCD capable of breaking the full current load. Remember that the full house

loading must be taken into consideration when calculating mains demand. Refer to IEE

regulations for wiring size to the appliance. The mains feed goes directly to the terminal

block identified on the schematic (on page 8) and the boiler itself. The earth must be

connected to the marked point.

Standard switching is maintained through the controls, zero voltage switching is used and a

separate power supply for programmer and room thermostat (if digital) should be used. In

some cases this may be a battery or a mains charger with rechargeable cells in the

programmer. This control circuit is identified on the schematic (on page 8) and will switch

the boiler internally.

In the case of a combined hot water and heating system a Y plan or similar can be used

with a three port motorised valve, in which case a separate mains supply will be required

to operate the valve which will be switched via a suitable programmer NOT the boiler PCB.

Use a relay if any voltage is present.

Always consult manufacturer's requirements and recommendations for controls, the above

advice is of a general nature only.

Guage

Expansion

Vessel

Filling Loop

3 Bar Expansion Valve

eGlow Boiler

RETURN

FLOW