Daewoo International DCP-490 사용자 설명서 - 페이지 10

{카테고리_이름} Daewoo International DCP-490에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daewoo International DCP-490 20 페이지. Projection clock radio

WHEN THE ALARM SOUNDS

1. When the alarm sounds, press " AL.OFF" button (1) to turn o alarm or press

"SNOOZE NAP/SLEEP" button (2) for snooze.

2. Once in snooze, alarm will sound again after 9 minutes

When the radio is o and the current time showing, press "DIMMER" button (4) to

change the brightness of the display between high and low.

(Note: Do not change the display brightness while setting the clock radio and

when the alarm is on.)

TIME PROJECTION

Press "PROJECTION ON/OFF" button (9) to turn time projection on and o . It is most

visible on a at white surface. Press "180º FLIP" button (6) to rotate time projection

by 180º. Tilt and adjust "time projection / focus dial" (12) as needed.

General Operations

1. Press "AL.OFF" button (1) to turn radio on and o . The radio station frequency will

appear on the is play.

2. Press "HOUR/TUN-" button (8) or "MIN/TUN+" button (11) to change radio

frequency. Or, press and hold down "HOUR/TUN-" button (8) or "MIN/TUN+"

button (11) for approximately 3 seconds to auto scan for the next available

station.

3. Press "AL1/VOL-" button (7) or "AL2/VOL+" button (10) to adjust volume level.

4. Radio will show the time in a few seconds after changing frequency. Press "HOUR/

TUN-" button (8) or "MIN/TUN+" button (11) to view radio frequency.

Pre-set Station Memory

1. The radio can store up to 10 FM stations. To store a station in memory, tune to

the desired radio station. Press and hold down "PRESET" button (5) and a number

starting with "P" on the display will ash. This "P" number represent one of the

ten memory stations. Press "HOUR/TUN-" button (8) or "MIN/TUN+" button (11)

to change the station number. Press "PRESET" button (5) to con rm.

3. To recall a pre-set station, turn the radio on. Press "PRESET" button (5)

repeatedly until station number is found. The station frequency will be display

momentarily.

Sleep mode

With the radio on, press "SNOOZE NAP/SLEEP" button (2) to enter sleep mode.

Digits represents radio to be automatically turned o in minutes. (Indicator F will

be on).