Dot Origin VTAP100 설치 매뉴얼 - 페이지 15

{카테고리_이름} Dot Origin VTAP100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dot Origin VTAP100 17 페이지. Desktop usb reader
Dot Origin VTAP100에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

4.4 Antennas

The VTAP100 OEM module has been tested with its integrated loop antenna, printed on the

PCB. There are no alternative antennas approved for use. If an external antenna is attached,

the new arrangement would require a new FCC approval.

4.5 Label and compliance information

The integrator must attach a label to the new equipment, hosting the VTAP100 OEM module,

which states 'Contains FCC ID: 2A282-VTAP100'.

4.6 Information on test modes

The following test modes are recommended to achieve states of maximum emission levels or

susceptibility in the VTAP100 OEM module:

1. VTAP100 OEM module powered on. Communicating with PC over USB. Continuously

reading tag.

2. VTAP100 OEM module powered on and tag present, but not communicating with external

device.

4.7 Additional testing requirements

The VTAP100 OEM module is only FCC authorised for use in compliance with the specific

FCC transmitter rules listed on the grant. The integrator is responsible for compliance to any

other FCC rules that apply to the host, which are not covered by the modular transmitter

grant of certification.

The final host product, with the VTAP100 OEM module installed, will still require Part 15

Subpart B compliance testing, to evaluate transmission effects when the VTAP100

OEM module and host equipment operate at the same time. Be aware that additional

testing can be required on the final integrated system. We recommend integrators refer to

further advice from the FCC OET Knowledge Base, such as 996369 D04 Module

Integration Guide v02.

VTAP100 OEM MODULE

INSTALLATION GUIDE

VTAP MOBILE WALLET READERS

PAGE 10