Dafra DRPB48 운영 매뉴얼 - 페이지 3

{카테고리_이름} Dafra DRPB48에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dafra DRPB48 10 페이지. Pneumatic blind rivet setting tool

DRPB48 Operation Manual

TOOL OPERATION FOR SETTING BLIND RIVETS

1) After completing the start-up preparations, place the rivet mandrel into the nosepiece, and

holding the tool to insert the rivet into the pre-drilled hole of the work piece that needs to be

fastened.

2) Pull the tool trigger (#43) to set the blind rivet in its position on work piece.

3) After setting the rivet, tilt the tool to the front in order to release the mandrel from inside the

tool or tilt back the tool and the mandrel will be released from the back of the tool into the

mandrel release protector. While using the tool, be sure always with the mandrel release

protector on the tool, in case a mandrel comes shooting out from the back and causes

injuries.

TOOL MAINTAINANCE

In order to maintain optimum performance after several weeks of regular use, add a few drops

of hydraulic oil on the inlet of the air adaptor (#47) of the tool in order to reduce the friction of

the tool parts since the oil will be blown inside the tool when tool is in operation.

After a period of use, the tool stroke may be reduced which indicated that the hydraulic oil in the

pneumatic tool needs to be refilled or changed;

1) Remove the screw (#9) with a hexagon wrench: