Dot Origin VTAP100 설치 매뉴얼 - 페이지 10

{카테고리_이름} Dot Origin VTAP100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dot Origin VTAP100 17 페이지. Desktop usb reader
Dot Origin VTAP100에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

3.3 Mounting points

The PCB has 2.7mm diameter mounting holes for fixing the unit. Either use the 50mm

spaced holes on the snap-off tabs, or remove those tabs and make use of the holes on the

body of the board. If you need to remove the tabs, we recommend carefully following the

perforations provided to avoid damage to the board, using a vice and pliers, or a PCB cutter.

Use 2-4 small nuts and bolts to mount the board securely.

Figure 3-2 VTAP100 PCB mounting holes - v4 Hardware

The user's smartphone should be able to tap within 10mm of the antenna on the PCB. The

antenna position should be clearly marked and easily accessed, so that users can position

their smartphone appropriately. Be aware that antennas are positioned differently in

different makes of smartphone. Apple iphones often have antennas near the top and

Android phones are more likely to have an antenna in the middle.

CAUTION: Mounting a VTAP board on metal can reduce performance of the VTAP100,

because metal can distort the NFC field. Never allow a metal surface between the

VTAP100 and the user's phone or card. If you have to mount the VTAP100 on metal, you

should ensure the separation is:

at least 6mm and insert a ferrite sheet between the VTAP100 and the metal surface, or

at least 25mm separation between the VTAP PCB and the metal, which will be achieved

if the VTAP100 is inserted in a compact case before mounting.

VTAP100 OEM MODULE

INSTALLATION GUIDE

VTAP MOBILE WALLET READERS

PAGE 5