Dot Origin VTAP100-PACS 설치 매뉴얼 - 페이지 4

{카테고리_이름} Dot Origin VTAP100-PACS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dot Origin VTAP100-PACS 14 페이지. Mobile nfc pass reader

Safety instructions

WARNING: INTENDED USE

The VTAP100 equipment is intended for use by suitably qualified integrators, who will integrate the

VTAP100-PACS (PCB) into their own hardware. Although an optional wallbox case can be supplied.

Components mounted on the VTAP100 PCB are not user-serviceable.

WARNING: ESD PRECAUTIONS

We recommend careful handling and storage of Electrostatic Sensitive Devices (ESDs) during

installation. The VTAP100-PACS (PCB) should always be protected by static shielding bags for

shipping or storage.

WARNING: POWER SUPPLY

Use only a MicroUSB to USB cable, or the optional captive USB cable, if any, to connect the

VTAP100-PACS PCB to a PC. (Never connect both at the same time). The VTAP100-PACS model can

alternatively be powered by connecting it to an access controller, using the Wiegand connector

supplied.

Using other cables will invalidate EMC emissions and immunity certifications.

The VTAP100 is rated at 5V DC @ 50 to 150mA for power over USB. When powered over Wiegand it

is rated at 8V DC @ 30 to 100mA

WARNING: USER DESIGNED ENCLOSURES

It is the responsibility of the integrator to ensure that their enclosure design for the VTAP100 retains

compliance with EMC emissions and immunity standards.

Integrators are responsible for evaluating their own end product (including the VTAP100-PACS PCB)

and obtaining separate approvals for the markets in which it will be sold or used.

VTAP100-PACS V3A INSTALLATION GUIDE

PAGE II