Dotco 21D Series 부품 설명서 - 페이지 2
{카테고리_이름} Dotco 21D Series에 대한 부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dotco 21D Series 12 페이지. .4 hp pistol grip
페이지 인쇄PL32--21D
September 14, 2001
PISTOL GRIP
Catalog
Numbers
21D--100G--38*
21D--101G--38
21D--102G--38
21D--103G--38
21D--104G--38
21D--105G--38
21D--106G--38
21D--107G--38
NOTE: "Model level 'G' " or other letter identifies the vintage of the tool and is used for identification or when
ordering spare parts since parts interchangeability may be affected. This letter is usually stamped on the tool's
nameplate in the position indicated. Do not use when ordering new tools.
GEARING REASSEMBLY
Planetary Gearing
Place a small amount of grease in each planet gear, as illustrated
at right, and place on a smooth clean surface. Insert a planet pin
— notched end up — in each gear. Then, install the correct
number of rollers ( 12 ) around each gear. Grease will hold the
rollers in position when the planet gears are removed.
Timing of the Step Reduction Gear Assembly
Assemble the planet gears into the planet cage, making sure the
notched planet pins fit over the planet cage washer. Rotate each
gear until the aligning hole — on the wnd of one gear — is
diametrically opposite the "X" mark of the other gear. Hold the
gears in this position and slip the planet cage into the internal
gear. This is important to avoid "wiping out" the gear teeth.
This is the only position where the gear teeth are lined up.
STRAIGHT HOUSING
Catalog
RPM
Numbers
25,000
21D--500G--38*
5,200
21D--501G--38
3,800
21D--502G--38
3,200
21D--503G--38
2,400
21D--504G--38
1,000
21D--505G--38
700
21D--506G--38
500
21D--507G--38
Tool Termination Number
RPM
[ 38* ]
-- standard with 1/4" chuck (1BA)
24,000
[ 40 ]
-- no chuck
4,750
[ 42 ]
-- Hvy Dty 1/4" chuck (7BA)
3,500
[ 43 ]
-- Hvy Dty 3/8" chuck (2BA)
2,800
[ 47 ]
-- 5/16" chuck (20BA)
2,100
[ 51 ]
-- 3/8" chuck (41BA)
900
[ 54 ]
-- 1/4" Hex
650
( * ) Indicates the standard duty 1/4" chuck
500
will be shipped unless otherwise specified.
FLAT SURFACE
Models:
21D--104
21D--504
DRILL POINT
Page 2
PLANET PIN
GREASE
PLANET
GEAR
X
X
"X"
STAMPED
Figure 1
Figure 2