DAGU Doodle Bot 매뉴얼 - 페이지 10

{카테고리_이름} DAGU Doodle Bot에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAGU Doodle Bot 12 페이지.

Changing the text message and size:

The first tab contains the setup and loop functions required for all Arduino code. The main loop is where you will

program the robot with different messages.

When you run the program, the robot will print the message: "I AM A ROBOT". There are two other samples that

allow the robot to print the alphabet or the numbers 0-9. Note that if you do not finish your message with

"END();" then the robot will repeat the message continuously.

The main loop also checks the battery voltage. If the battery is too flat then the robot will stop and the D13 LED

will flash quickly to indicate the battery is flat.

To change the size of the text you must change the value of "charsize" in the "Constants.h" tab. This is a whole

number from 1 to 255 with 1 being the smallest.

You can change the point at which the robot decides the battery is too flat in the "constants.h" tab by changing

the value of "lowbat". A value of 512 is approximately 5V. Do not set this too low otherwise the bootloader could

be corrupted.