Asus MB16AHV 사용자 설명서 - 페이지 25

{카테고리_이름} Asus MB16AHV에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus MB16AHV 26 페이지. Portable usb monitor

Problem

After connecting with the USB Type-C

source device, the power LED lights

continuously blinking or showing ASUS

logo repeatly

*1: White color background will consume higher power, so it's better to use white color

background to test the power limit from source USB Type-C device.

*2: If the monitor does not re-start when adjusting to value 100, that means source USB Type-C

device has sufficient power supply.

ASUS USB Type-C Monitor MB16AHV

Possible Solution

• Insufficient power supply from source

USB Type-C devices. Please follow below

steps:

1. Press the Blue Light Filter button , and

then connect the USB Type-C cable.

This operation will enable built-in safe

mode. After displaying ASUS logo, please

release the Blue Light Filter button. After

ASUS Logo disappearing, there is "safe

mode" message OSD showing up. Once

"safe mode" message OSD disappears,

please set background color to white

image or nearly white image (*1).

2. Press MENU button, main menu OSD

is showing. The upper left corner of the

OSD will display small red-colored font

"S", indicating it is now in safe mode.

Enter brightness setup, press the up key

to tune up brightness. During the process,

please note down brightness value "Y" up

until MB16AC re-start.(*2). For example, if

brightness value shows "70" and MB16AC

restarts when adjusting to "71", "70" is the

"Y" value to note down and is the highest

brightness value for the connecting USB-C

source device.

3. Press MENU button, main menu OSD

is showing. The upper left corner still

indicate "S" as safe mode. Adjust the OSD

brightness value to "Y"

4. Close the OSD and press Low Blue Low

Filter hot key for 5 seconds to turn off safe

mode.

5. Complete.

3-11